NFC-KIT-CASE Fluke Networks Fiber Optic Cleaning Kit with Case

Use the Fluke Networks® NFC-Kit-Case Fiber Optic Cleaning Kit with Case to ensure all fiber end-faces are clean before every mating. Lint-free materials enable optimal wet/dry cleaning sequence. Swabs are designed to fit many connector port styles. This kit eliminates contamination and fiber link failure. It contains a cleaning cube with wipes, 10 cards with sealed cleaning zones, 9-gram solvent pen plus 50 2.5-mm and 25 1.25-mm port cleaning swabs in a rugged case.
The NFC-Cube Cleaning Cube contains wipes to clean 50 end-faces. NFC-SolventPen dispenses a specially designed fiber solvent precisely. Pull a clean wipe from cube and apply a small spot of solvent to starting edge. Holding connector perpendicularly, swipe end-face from wet spot into dry zone. You get two NFC-Cards-5pack Fiber Optic Cleaning Cards that feature 12 sealed cleaning zones each for troubleshooting. Remove one plastic cover and apply a small spot of solvent to starting corner of cleaning zone. Hold connector perpendicularly and swipe end-face from wet spot into dry zone.
NFC-Swabs-1.25mm contains 25 LC and MU port cleaning swabs. The NFC-Swabs-2.5mm features 50 SC and ST 2.5-mm port cleaning swabs. Swabs may be used with cube. After pulling a clean wipe from cube, apply a small spot of solvent to starting edge of wipe. Touch swab to wet spot on wipe for 3 seconds to absorb a minimal amount of solvent. A damp swab works better than a wet one. Applying solvent from pen directly to swab would use excessive solvent. Insert swab into port and turn several times while applying gentle pressure. Follow damp swab with dry one, using same procedure to remove any remaining solvent from end-face and alignment sleeve. Replacement products also may be ordered separately.