Jonard / OK Industries PTX-KIT1 Cordless Wrap & Unwrap Tool Kit

The PTX wire wrapping tool features an ergonomic design with lightweight, well-balanced construction, reversible motor, dual-finger short-throw trigger, an LED indicator for low voltage and a long handle to reduce muscle strain. The recessed wrap/unwrap switch is easy to access at the rear face of the housing and is protected from impact if the tool is dropped. Its rugged housing encases a high-torque planetary gear drive that can wrap or unwrap 18 to 32 AWG wire, and is compatible with the full range of industry-standard bits and sleeves.

This battery-powered version requires an initial charge of the battery for at least eight hours. The LED will illuminate to indicate that the battery is present in the charger. LED will remain lit as long as the battery is present, even after full charging but there is no danger in leaving the battery in the charger for longer than eight hours. When the battery begins to lose its charge (at aproximately 3.3-V), the red LED indicator located on the top surface of the tool will begin to glow. At this point, depending on the application, the battery should still contain enough charge for several hundred additional wrapping or unwrapping operations. After approximately 500-700 uses, the battery should be disposed of and replaced. The PTX-B is an environmentally friendly NiMH battery which can be disposed of along with normal refuse.